Hydrogen is considered a promising alternative to conventional fossil fuels, as it can be easily produced from renewable energy sources. While electrocatalytic water splitting can achieve near-unity faradaic efficiency in producing hydrogen from water, the widespread implementation of large-scale water electrolysis is hindered by reliance on costly platinum group metal-based electrocatalysts. Here, we report on the rational design of Molybdenum-containing SiCN composites (Mo–SiCN) through an active-filler controlled pyrolysis (AFCOP) strategy. Our investigation into the composite's microstructural evolution revealed the formation of a Mo4.8Si3C0.6 Nowotny phase at a relatively low temperature of 1000 °C. After optimization, the resulting catalyst demonstrated a Tafel slope below 95 mV dec−1 and an overpotential near 575 mV at a normalized current density of 1 mA μF−1. As a proof of concept, the AFCOP strategy was employed to engineer a crack-free Mo–SiCN micropattern, enabling the miniaturization of a Pt-free electrochemical water splitting (EWS) reactor. Produced via soft lithography, the Mo–SiCN pattern exhibits feature sizes ranging from 10 to 200 μm, with near-net-shape replication and a Young's modulus of ≈60 GPa.

Inter-individual variability in muscle responses to mechanical stress during exercise is poorly understood. Therefore, new cell culture scaffolds are needed to gain deeper insights into the cellular mechanisms underlying the influence of mechanical stress on human myogenic progenitor cells behavior. To this end, we propose the first in vitro model involving uniaxial mechanical stress applied to aligned human primary muscle-derived cells, employing a biocompatible organic–inorganic photostructurable hybrid material (OIPHM) covalently attached to a stretchable PDMS support. Using a laser printing technique with an additive photolithographic process, we optimally micropatterned the PDMS support to create longitudinal microgrooves, achieving well-aligned muscle fibers without significantly affecting their diameter. This support was biofunctionalized with peptide sequences from the ECM, which interact with cellular adhesion receptors and prevent myotube detachment induced by stretching. X-ray photoelectron spectroscopy (XPS) of biofunctionalized PDMS with RGD-derived peptide deposition revealed a significant increase in nitrogen compared to silicon, associated with the presence of a 380 nm thick layer measured by atomic force microscopy (AFM). Upon cell culture, we observed that functionalization with an RGD peptide had a beneficial impact on cell fusion rate and myotube area compared to bare PDMS. At the initiation of the stretching protocol, we observed a three-fold rapid and transient increase in RNA expression for the mechanosensitive ion channel protein piezo and a decrease in the ratio of nuclei expressing myogenin relative to the total nuclei count (43 ± 16% vs. 6 ± 6%, p < 0.01). Compared to day 0 of differentiation, stretching the myotubes induced MHC and Titin colocalization (0.66 ± 0.13 vs. 0.93 ± 0.05, p < 0.01), favoring sarcomere organization and maturation. In this study, we propose and validate an optimized protocol for culturing human primary muscle-derived cells, allowing standardized uniaxial mechanical stress with a biocompatible OIPHM covalently linked to PDMS biofunctionalized with an ECM-derived peptide, to better characterize the behavior of myogenic progenitor cells under mechanical stress in future studies.

By using the self-consistent Born approximation, we investigate disorder effect induced by shortrange impurities on the band-gap of a seminal two-dimensional (2D) system, whose phase diagram contains trivial, single-band-inverted and double-band-inverted states. Following the density-ofstates (DOS) evolution, we demonstrate multiple closings and openings of the band-gap with the increase of the disorder strength. Calculations of the spectral function describing the quasiparticles at the Γ point of the Brillouin zone evidence that the observed band-gap behavior is unambiguously caused by the topological phase transitions due to the mutual inversions between the first and second electron-like and hole-like subbands. We also find that an increase in the disorder strength in the double-inverted state always leads to the band-gap closing due to the overlap of the tails of DOS from conduction and valence subbands.