Biological or artificial microswimmers move performing trajectories of different kinds such as rectilinear, circular, or spiral ones. Here, we report on circular trajectories observed for active Janus colloids trapped at the air−water interface. Circular motion is due to asymmetric and nonuni form surface properties of the particles caused by fabrication. Motion persistence is enhanced by the partial wetted state of the Janus particles actively moving in two dimensions at the air−water interface. The slowing down of in plane and out of plane rotational diffusions is described and discussed.

A simple model is introduced to describe the failure mechanisms in soft thermoplastic elastomers. In particular, we address the strong embrittlement with increasing temperature observed in strain rate imposed tensile experiments. This behavior is in sharp contrast to classic thermoplastics and seems to be general for these types of systems, irrespective of their exact chemical nature. We show that a kinetic model describing the supramolecular association of hard blocks in terms of an Eyring rate equation captures the correct stress and temperature dependence of failure strain. We model the material as a transient network, whose failure is associated with the loss of connectivity. The network percolation threshold, a key parameter of the model, is studied with numerical simulations, in order to investigate the interplay between structure, connectivity, and mechanical properties.

Quantitative characterization of the average structure of dense nanoparticle assemblies and aggregates is a common problem in nanoscience. Small-angle scattering is a suitable technique, but it is usually limited to not too big assemblies due to the limited experimental range, low concentrations to avoid interactions, and monodispersity to keep calculations tractable. In the present paper, a straightforward analysis of the generally available scattered intensity – even for large assemblies, at high concentrations – is detailed, providing information on the local volume fraction of polydisperse particles with hard sphere interactions. It is based on the identical local structure of infinite homogeneous nanoparticle assemblies and their subsets forming finite-sized clusters. The approach is extended to polydispersity, using Monte-Carlo simulations of hard and moderately sticky hard spheres. As a result, a simple relationship between the observed structure factor minimum – termed the correlation hole – and the average local volume fraction  on the scale of neighboring particles is proposed and validated through independent aggregate simulations. The relationship shall be useful as an efficient tool for the structural analysis of arbitrary aggregated colloidal systems.

Colloidal suspensions of anisotropic nanoparticles can spontaneously self-organize in liquid-crystalline phases beyond some concentration threshold. These phases often respond to electric and magnetic fields. At lower concentrations, usual isotropic liquids are observed but they can display very strong Kerr and Cotton-Mouton effects (i.e., field-induced particle orientation). For many examples of these colloidal suspensions, the solvent is water, which hinders most electro-optic applications. Here, for goethite (α-FeOOH) nanorod dispersions, we show that water can be replaced by polar aprotic solvents, such as N-methyl-2-pyrrolidone (NMP) and dimethylsulfoxide (DMSO), without loss of colloidal stability. By polarized-light microscopy, small-angle X-ray scattering and electro-optic measurements, we found that the nematic phase, with its field-response properties, is retained. Moreover, a strong Kerr effect was also observed with isotropic goethite suspensions in these polar aprotic solvents. Furthermore, we found no significant difference in the behavior of both the nematic and isotropic phases between the aqueous and non-aqueous dispersions. Our work shows that goethite nanorod suspensions in polar aprotic solvents, suitable for electro-optic applications, can easily be produced and that they keep all their outstanding properties. It also suggests that this solvent replacement method could be extended to the aqueous colloidal suspensions of other kinds of charged anisotropic nanoparticles.

We study the fracture of reversible double transient networks, constituted of water suspensions of entangled surfactant wormlike micelles reversibly linked by various amounts of telechelic polymers. We provide a state diagram that delineates the regime of fracture without necking of the filament from the regime where no fracture or break-up has been observed. We show that filaments fracture when stretched at a rate larger than the inverse of the slowest relaxation time of the networks. We quantitatively demonstrate that dissipation processes are not relevant in our experimental conditions and that, depending on the density of nodes in the networks, fracture occurs in the linear viscoelastic regime or in a non-linear regime. In addition, analysis of the crack opening profiles indicates deviations from a parabolic shape close to the crack tip for weakly connected networks. We demonstrate a direct correlation between the amplitude of the deviation from the parabolic shape and the amount of non linear viscoelasticity.

An original setup combining a very stable loading stage, an atomic force microscope and an environmental chamber, allows to obtain very stable sub-critical fracture propagation in oxide glasses under controlled environment, and subsequently to finely characterize the nanometric roughness properties of the crack surfaces. The analysis of the surface roughness is conducted both in terms of the classical root mean square roughness to compare with the literature, and in terms of more physically adequate indicators related to the self-affine nature of the fracture surfaces. Due to the comparable nanometric scale of the surface roughness, the AFM tip size and the instrumental noise, a special care is devoted to the statistical evaluation of the metrologic properties. The 2 roughness amplitude of several oxide glasses was shown to decrease as a function of the stress intensity factor, to be quite insensitive to the relative humidity and to increase with the degree of heterogeneity of the glass. The results are discussed in terms of several modeling arguments concerning the coupling between crack propagation, material's heterogeneity, crack tip plastic deformation and water diffusion at the crack tip. A synthetic new model is presented combining the predictions of a model by Wiederhorn et al. [1] on the effect of the material's heterogeneity on the crack tip stresses with the self-affine nature of the fracture surfaces.

Lignin is one of the most abundant bio-polymers present in nature and its valorization is still a challenge to an economically feasible biorefinery concept. The heterogeneity and scarce reactivity of lignin are significant hurdles to the development of new valorization processes. We propose an in situ extraction electrochemical depolymerization system. Kraft lignin dissolved in a deep eutectic solvent together with an extractant phase is able to form a stable emulsion. Electro-oxidation of the emulsion using a nickel or graphite electrode results in successful depolymerization and simultaneous fractionation of the products. Over-oxidation of the depolymerization products is anticipated to be suppressed upon swift extraction from the lignin phase into the extraction phase.