We investigate the dynamics of freely expanding liquid sheets prepared with fluids with different rheological properties, (i) viscous fluids with a zero-shear viscosity $\eta_0$ in the range $(1-1000) \, \mathrm{mPa.s}$ and (ii) viscoelastic Maxwell fluids whose elastic modulus, $G_0$, characteristic relaxation time, $\tau$, and zero-shear viscosity, $\eta_0=G_0 \tau$, can be tuned over several orders of magnitude. The sheets are produced by impacting a drop of fluid on a small cylindrical solid target. For viscoelastic fluids, we show that, when $\tau$ is shorter than the typical lifetime of the sheet ($\sim 10$ ms), the dynamics of the sheet is similar to that of Newtonian viscous liquids with equal zero-shear viscosity. In that case, for little viscous samples ($\eta_0 <\sim 30$ mPa.s), the maximal expansion of the sheet, $d_{\rm{max}}$, is independent of $\eta_0$, whereas for more viscous samples, $d_{\rm{max}}$ decreases as $\eta_0$ increases. We provide a simple model to account for the dependence of the maximal expansion of the sheet with the viscosity that is based on an energy balance between inertia, surface tension and viscous shear dissipation on the solid target, and which accounts well for our experimental data. By contrast, when $\tau$ is longer than the typical lifetime of the sheet, the behavior drastically differs. The sheet expansion is strongly enhanced as compared to that of viscous samples with comparable zero-shear viscosity, but is heterogeneous with the occurrence of cracks, revealing the elastic nature of the viscoelastic fluid.

We develop and thoroughly test a stress-controlled, parallel plates shear cell that can be coupled to an optical microscope or a small angle light scattering setup, for simultaneous investigation of the rheological properties and the microscopic structure of soft materials under an imposed shear stress. In order to minimize friction, the cell is based on an air bearing linear stage, the stress is applied through a contactless magnetic actuator, and the strain is measured through optical sensors. We discuss the contributions of inertia and of the small residual friction to the measured signal and demonstrate the performance of our device in both oscillating and step stress experiments on a variety of viscoelastic materials.

We couple a laser-based, space-resolved dynamic light scattering apparatus to a universal testing machine for mechanical extensional tests. We perform simultaneous optical and mechanical measurements on polyether ether ketone, a semi-crystalline polymer widely used in the industry. Due to the high turbidity of the sample, light is multiply scattered by the sample and the diffusing wave spectroscopy (DWS) formalism is used to interpret the data. Space-resolved DWS yields spatial maps of the sample strain and of the microscopic dynamics. An excellent agreement is found between the strain maps thus obtained and those measured by a conventional stereo-correlation bench. The microscopic dynamics reveals both affine motion and plastic rearrangements. Thanks to the extreme sensitivity of DWS to displacements as small as 1 nm, plastic activity and its spatial localization can be detected at an early stage of the sample deformation, making the technique presented here a valuable complement to existing material characterization methods.