Accueil >
Production scientifique
(139) Production(s) de GENIX A.-C.
|
|
On the absence of structure factors in concentrated colloidal suspensions and nanocomposites
Auteur(s): Genix A.-C., Oberdisse J.
(Article) Publié:
European Physical Journal E, vol. 46 p.46 (2023)
Texte intégral en Openaccess :
Ref HAL: hal-04244864_v1
Ref Arxiv: 2310.14682
DOI: 10.1140/epje/s10189-023-00306-6
Ref. & Cit.: NASA ADS
Exporter : BibTex | endNote
Résumé: Small-angle scattering is a commonly used tool to analyze the dispersion of nanoparticles in all kinds of matrices. Besides some obvious cases, the associated structure factor is often complex and cannot be reduced to a simple interparticle interaction, like excluded volume only. In recent experiments, we have encountered a surprising absence of structure factors (S(q) = 1) in scattering from rather concentrated polymer nanocomposites [A.-C. Genix et al, ACS Appl. Mater. Interfaces 11 (2019) 17863]. In this case, quite pure form factor scattering is observed. This somewhat “ideal” structure is further investigated here making use of reverse Monte Carlo simulations in order to shed light on the corresponding nanoparticle structure in space. By fixing the target “experimental” apparent structure factor to one over a given q-range in these simulations, we show that it is possible to find dispersions with this property. The influence of nanoparticle volume fraction and polydispersity has been investigated, and it was found that for high concentrations only a high polydispersity allows reaching a state of S = 1. The underlying structure in real space is discussed in terms of the pair-correlation function, which evidences the importance of attractive interactions between polydisperse nanoparticles. The calculation of partial structure factors shows that there is no specific ordering of large or small particles, but that the presence of attractive interactions together with polydispersity allows reaching an almost “structureless” state.
|
|
|
Editorial: Nanocomposites with interfaces controlled by grafted or adsorbed polymers
Auteur(s): Holderer O., Genix A.-C., Kruteva M., Oberdisse J.
(Article) Publié:
Frontiers In Physics, vol. 10 p.1117549 (2023)
|
|
|
How Tuning Interfaces Impacts the Dynamics and Structure of Polymer Nanocomposites Simultaneously
Auteur(s): Genix A.-C., Bocharova Vera, Carroll Bobby, Dieudonne-George P., Chauveau E., Sokolov Alexei, Oberdisse J.
(Article) Publié:
Acs Appl. Mater. Interfaces, vol. 15 p.7496-7510 (2023)
Texte intégral en Openaccess :
Ref HAL: hal-04244949_v1
Ref Arxiv: 2310.14680
DOI: 10.1021/acsami.2c18083
Ref. & Cit.: NASA ADS
Exporter : BibTex | endNote
Résumé: Fundamental understanding of macroscopic properties of polymer nanocomposites (PNCs) remains difficult due to the complex interplay of microscopic dynamics and structure, namely interfacial layer relaxations and three-dimensional nanoparticle arrangements. The effect of surface modification by alkyl methoxysilanes at different grafting densities has been studied in PNCs made of poly(2-vinylpyridine) and spherical 20 nm silica nanoparticles (NPs). The segmental dynamics has been probed by broadband dielectric spectroscopy, and the filler structure by small-angle X-ray scattering and reverse Monte Carlo simulations. By combining the particle configurations with the interfacial layer properties, it is shown how surface modification tunes the attractive polymer-particle interactions: bare NPs slow down the polymer interfacial layer dynamics over a thickness of ca. 5 nm, while grafting screens these interactions. Our analysis of interparticle spacing and segmental dynamics provides unprecedented insight into the effect of surface modification on the main characteristics of PNCs: particle interactions and polymer interfacial layers.
|
|
|
Influence of the Graft Length on Nanocomposite Structure and Interfacial Dynamics
Auteur(s): Genix A.-C., Bocharova Vera, Carroll Bobby, Dieudonne-George P., Chauveau E., Sokolov Alexei, Oberdisse J.
(Article) Publié:
Nanomaterials, vol. 13 p.748 (2023)
Texte intégral en Openaccess :
Ref HAL: hal-04244883_v1
Ref Arxiv: 2310.11201
DOI: 10.3390/nano13040748
Ref. & Cit.: NASA ADS
Exporter : BibTex | endNote
Résumé: Both the dispersion state of nanoparticles (NPs) within polymer nanocomposites (PNCs) and the dynamical state of the polymer altered by the presence of the NP/polymer interfaces have a strong impact on the macroscopic properties of PNCs. In particular, mechanical properties are strongly affected by percolation of hard phases, which may be NP networks, dynamically modified polymer regions, or combinations of both. In this article, the impact on dispersion and dynamics of surface modification of the NPs by short monomethoxysilanes with eight carbons in the alkyl part (C8) is studied. As a function of grafting density and particle content, polymer dynamics is followed by broadband dielectric spectroscopy and analyzed by an interfacial layer model, whereas the particle dispersion is investigated by small-angle X-ray scattering and analyzed by reverse Monte Carlo simulations. NP dispersions are found to be destabilized only at the highest grafting. The interfacial layer formalism allows the clear identification of the volume fraction of interfacial polymer, with its characteristic time. The strongest dynamical slow-down in the polymer is found for unmodified NPs, while grafting weakens this effect progressively. The combination of all three techniques enables a unique measurement of the true thickness of the interfacial layer, which is ca. 5 nm. Finally, the comparison between longer (C18) and shorter (C8) grafts provides unprecedented insight into the efficacy and tunability of surface modification. It is shown that C8-grafting allows for a more progressive tuning, which goes beyond a pure mass effect.
|
|
|
Recent scattering approaches to structure and dynamics of polymer nanocomposites
Auteur(s): Kruteva M., Genix A.-C., Holderer O., Oberdisse J.
(Article) Publié:
Frontiers In Soft Matter, vol. 2 p.992563 (2022)
Ref HAL: hal-04244916_v1
DOI: 10.3389/frsfm.2022.992563
Exporter : BibTex | endNote
Résumé: The characterization of polymer nanocomposites on molecular length scales and timescales is a challenging task, which is also indispensable for the understanding of macroscopic material's properties. Neutron scattering is one of the techniques which are very well-suited for studying the structure and molecular motion in such soft matter systems. X-rays can also be used for the same purpose, however, with higher energy and thus a different focus on dynamics, where they are better suited for nanoparticle motion. In this mini-review, we aim at highlighting recent results in the field of polymer nanocomposites, including nanoparticle structure in various experimental systems, from model to industrial, and polymer and particle dynamics. This allows establishing the link between microscopic and macroscopic properties, in particular rheology.
|
|
|
SANS studies of polymer structure in nanocomposites
Auteur(s): Oberdisse J., Genix A.-C.
Conférence invité: 50 years of D11: A history of SANS at ILL (Grenoble, FR, 2022-09-25)
Ref HAL: hal-03817747_v1
Exporter : BibTex | endNote
Résumé: As compared to other techniques of analysis of nanostructures, small-angle neutron scattering has always been way better in terms of design of special contrast situations, and worse for statistics due to inherently low flux. SANS beamlines at ILL, and in particular D11 dedicated to soft matter studies, have allowed to keep the first advantage, while providing excellent experimental conditions respect to, including with respect to flux.In this talk, I will present some recent studies of polymer structure in nanocomposites. Such materials have striking mechanical and dynamical properties, in particular the dynamics of the polymer close to the nanoparticles has triggered a large body of experimental and theoretical studies. The possible slow-down of the polymer corresponds to higher moduli, and the percolation of any hard phase, particles or slowed-down polymer, has a strong impact on the macroscopic mechanical properties. If one wishes to specifically characterize the structure of the polymer, SANS is one of the best options. By blending hydrogenated and deuterated chains, while matching the filler silica nanoparticles, we have recently provided evidence for chain-mass dependent bulk or interfacial segregation, and modelling and experimental results will be critically reviewed. In a second study, we have characterized the particle dispersion by small-angle scattering and reverse Monte Carlo modelling, and used it to improve the determination of the thickness of the polymer interfacial layer seen by broadband dielectric spectroscopy. Both the general nanoparticle dispersion and the characteristic time of this interfacial layer has been shown to be tunable by surface modification, paving the way for a precise control of mechanical properties of polymer nanocomposites in the future.
|