Ref HAL: hal-02873048_v1
DOI: 10.1103/PhysRevB.102.035201
Exporter : BibTex | endNote
Résumé:

Time-resolved photoluminescence and light-induced transient grating techniques were applied for temperature and excitation dependent internal quantum efficiency and carrier diffusion investigation in silicon-doped epilayer and AlxGa1-xN MQWs (x > 0.6). Decrease of photoluminescence efficiency at high excitations correlated with increase of diffusion coefficient as well as nonradiative recombination rate, indicating excitation and temperature dependent localized exciton density reduction. Excitation-dependent lifetime decrease was less pronounced than the corresponding drop of the time-integrated photoluminescence efficiency dominated by thermal dissociation of excitons. At lowest excitations excitons were found captured to vacancy complexes. With increase of excitation exciton ionization appeared, leading to enhanced nonradiative recombination of holes on aluminum vacancies and simultaneous droop of PL efficiency due to saturated bimolecular free carrier plasma recombination. At initial recombination stages and high excitations diffusive recombination on dislocations was also revealed. Modelling provided free exciton binding energies of 104, 140 meV in the MQWs and in the layer; exciton localization energies in 12-35 meV range; localized exciton lifetimes in 2-4 ns range; free exciton and carrier radiative recombination rate coefficients of rex = (0.6 0.2)109(T/300)-1 1/s and Brad = (7 1)10-10(T/300)-3/2 cm3/s, respectively. Vacancy complex capture cross section for excitons was determined to be = (2 1)10-16(300/T)2 cm2. Electron and hole capture cross sections to aluminum vacancy were modeled (1.5 1)10-13 cm2 and (7 1)10-13 cm2, respectively. Dislocation Coulomb radius for free carrier recombination was found to be 12-15 nm.

Ref HAL: hal-02615364_v1
DOI: 10.1021/acs.chemmater.0c00830
Exporter : BibTex | endNote
Résumé:

Hexagonal boron nitride (hBN) is attracting much attention due to its tremendous applications including nanophotonic and electronic devices, substrates for two-dimensional (2D) materials, heat management materials, etc. To achieve the best device performance, large area hBN single crystals are required. Herein, large area (>500 microns each) high-quality (defect density < 0.52/μm2) bulk hBN single crystals are grown from molten metal solutions with a temperature gradient. The narrow Raman linewidths of the intralayer E2g mode peak and the interlayer shear mode, the strong and sharp phonon-assisted transition photoluminescence peaks, and the high thermal conductivity demonstrate that the hBN produced by this method are high crystal quality with a low density of defects. Atomic force microscope images show that atomically flat layers of hBN can be produced by exfoliation. This study not only demonstrates a new strategy for growing large hBN single crystals, but also provides high quality thick and thin hBN layers for nano device applications

Ref HAL: hal-02493073_v1
DOI: 10.1063/1.5140030
WoS: 000519594400001
Exporter : BibTex | endNote
Résumé:

Nitrogen-vacancy centers in diamonds possess an electronic spin resonance that strongly depends on temperature, which makes them efficient temperature sensors with sensitivity down to a few mK/√Hz. However, the high thermal conductivity of the host diamond may strongly damp any temperature variations, leading to invasive measurements when probing local temperature distributions. In the view of determining possible and optimal con gurations for diamond-based wide- eld thermal imaging, here, we investigate both experimentally and numeri- cally the effect of the presence of diamonds on microscale temperature distributions. Three geometrical con gurations are studied: a bulk diamond substrate, a thin diamond layer bonded on quartz, and diamond nanoparticles dispersed on quartz. We show that the use of bulk diamond substrates for thermal imaging is highly invasive in the sense that it prevents any substantial temperature increase. Conversely, thin diamond layers partly solve this issue and could provide a possible alternative for microscale thermal imaging. Dispersions of diamond nanoparticles throughout the sample appear as the most relevant approach as they do not affect the temperature distribution, although NV centers in nanodiamonds yield lower temperature sensitivities than bulk diamonds.

Ref HAL: hal-02428517_v1
Ref Arxiv: 2001.00912
DOI: 10.1103/PhysRevApplied.13.044079
WoS: 000529842800003
Ref. & Cit.: NASA ADS
Exporter : BibTex | endNote
1 Citation
Résumé:

We demonstrate that magnetic skyrmions with diameters around 60 nm can be stabilized at room temperature and zero external magnetic field in an exchange-biased Pt/Co/NiFe/IrMn multilayer stack. This is achieved through an advanced optimization of the multilayer stack composition in order to balance the different magnetic energies controlling the skyrmion size. Magnetic imaging is performed both with magnetic force microscopy and scanning Nitrogen-Vacancy magnetometry, the latter providing unambiguous measurements at zero external magnetic field. In such samples, we show that exchange bias provides an immunity of the skyrmion spin texture to moderate external magnetic field, in the tens of mT range, which is an important feature for applications as memory devices. These results establish exchange-biased multilayer stacks as a promising platform towards the effective realization of memory and logic devices based on magnetic skyrmions.

Commentaires: 5 pages, 3 figures